John Lewis JLFSEC612 Manual de usuario descargar pdf (Pagina 41)

Make the hole, in which you install the

component on the wall, approximately 77 mm

from the top of the appliance. Make sure that

the component is on the correct height. Use a

screw to install it. (See the second illustration).

50 mm

77 mm

A

Make sure that the anti-tilt protection goes into

the hole on the rear wall of the appliance. After

you push the appliance, the anti-tilt protection

must to go into the hole for a minimum of 20

mm.

The space between the bench cupboards

cannot be wider than the appliance. If this

occurs, adjust the space on the two sides of the

appliance. Put the appliance in the center of the

space.

Electrical installation

Warning! Only a qualified and

competent person must do the

electrical installation.

The manufacturer is not responsible if

you do not follow safety precautions

from the chapter "Safety information".

This appliance is supplied without a main plug or

a main cable.

Covering terminal board

The recommended cross-section area is six

square millimetres (6 mm²).

When you refit the mains terminal cover, make

sure that the lower tabs are located inside the

bottom edge of the aperture, before you fix the

two screws into the top edge of the mains

terminal cover.

Make sure that the cover is securely fastened.

To open the cover of terminal board

obey the procedure in opposite

sequence.

Terminal board

Make sure that the links are fitted as shown.

NNN

LL

Do not remove blanking plates.

Cooker user manual 41

1 2 ... 36 37 38 39 40 41 42 43 44 45 46 47 48

Comentarios a estos manuales

Sin comentarios