John Lewis JLBIGH602 Manual de usuario descargar pdf (Pagina 9)

Daily use

Warning! Refer to the Safety

chapters.

Ignition of the burner

Warning! Be very careful when

you use open fire in kitchen

environment. Manufacturer

decline any responsibility in case

misuse of the flame

Always light the burner before you put

cookware.

To light the burner:

1. Push the control knob down and turn it

counterclockwise to the maximum position

(

).

2. Keep the control knob pushed for

approximately 5 seconds; this will let

thermocouple to warm up. If not, the gas

supply will be interrupted.

3. Adjust the flame after it is regular.

If after some tries the burner does not

light, check if the crown and its cap are

in correct positions.

A

B

C

D

A) Burner cap

B) Burner crown

C) Ignition candle

D) Thermocouple

Warning! Do not keep the

control knob pushed for more

than 15 seconds.

If the burner does not light after

15 seconds, release the control

knob, turn it into off position and

try to light the burner again after

minimum 1 minute.

Important! In the absence of electricity

you can ignite the burner without

electrical device; in this case approach

the burner with a flame, push the

relevant knob down and turn it counter-

clockwise to maximum gas release

position.

If the burner accidentally goes out,

turn the control knob to the off

position and try to light the burner

again after minimum 1 minute.

The spark generator can start

automatically when you switch on the

mains, after installation or a power cut.

It is normal.

Turning the burner off

To put the flame out, turn the knob to the

symbol

.

Warning! Always turn the flame

down or switch it off before you

remove the pans from the

burner.

Hob user manual 9

1 2 3 4 5 6 7 8 9 10 11 12 13 14 ... 23 24

Comentarios a estos manuales

Sin comentarios