John Lewis SBSKITB Manual de usuario descargar pdf (Pagina 7)

• Carefully place the unit on the floor, following the instructions on the packaging to make sure the unit is

facing upwards.

• Open the bottom part of packaging and remove the corner protection.

• Screw the M8 nuts (4) (bag 4) on the respective front feet , see Fig. (A).

• Screw the front feet (15) on the bracket of the unit see Fig. (B) using the dimension indicated in Fig. (C).

• Position the rear feet (14) on the compressor support plate, see Fig. (C).

• Insert the pin (13), using a hammer, so that it does not protrude outside the foot see Fig. (D).

• Carefully reposition the appliance in the upright position and remove the packaging completely.

• Operation to be carried out on both units.

• Repeat this operation for the second unit.

1 2 3 4 5 6 7 8 9 10 11 12 ... 23 24

Sin comentarios

John Lewis SBSKITB Manual de usuario Pagina 7